SRX-550 upgraded to HM and JunOS 18.1R1.9 - J-Web doesn't work
Hi, everybody!I have SRX-550 (RE-SRXSME-SRX550) upgraded to HM (4GB RAM, 8GB SD) and JunOS 18.1R1.9 upgraded from JunOS 12. We purchased this upgraded device from one of Juniper Official Distributors....
View ArticleSRX DSL Redundancy
Hi all, Should be a simple answer to this one I expect: I have hunted for the docs on this and cannot find anything relevant: If I have an SRX340 and purchase a DSL module for the device (RJ11) and...
View Articleconfiguring dual internet uplink with BFD traffic on both inet interfaces
Hello Everyone, I am a total newbie to the SRX world. I have a few problems with a very custom configuration that I am trying out for the first time. We have Nuage network SD-WAN redundancy group...
View ArticleNTP Polling Frequency
I have had my SRX setup to use an NTP source for a while and for the most part, works just fine. Every now and then I notice that the time seems to drift a bit more than I think it should given that...
View ArticleSRX 4200 and SRX 1500 support SSL VPN(Dynamic VPN) or not?
Dear JuniperDoes SRX4200 and 1500 support SSL VPN(Dynamic VPN)?. If not, Which feature we can use?
View ArticleClik here to view.
Intra Zone Configuration
Hi all, I am looking to reduce the number of zones an SRX (currenlty has 1 zone per sub-interface), its needed for migration to another SRX with zone limitation..What would be the easiest way to...
View ArticleScreen option on SRX
Hi I would like to protect DNS, HTTP and HTTPs flood from external network. Which screen option feature can protect all floods?
View ArticleDefault DynamicVPN config on SRX100H2 does not allow remote access
We purchased an SRX100H2 about 3 years ago and it has been working well. We recently decided to enable remote access for a single user through its IPSec VPN feature. We factory reset the gateway and...
View Articleafter upgrade too 15.1X49-D140.2 screen logging stopped
hello upgrade to 15.1X49-D140.2 in july, i noticed our screen loggin has stopped the screen is still havtice and the counters are incresing but it is not logging at all ???
View ArticleLink Aggregation - SRX firewall - question.
Hi Guys,i need to configure a link aggregation in a SRX firewall 1500. However, i´m afraid with CPU/Memory utilization, because, nowadays we have IDP service enabled, and IPSEC VPN Site to Site enabled...
View ArticleSRX3400 management port.
Hi,Can we configure any other port as management port on SRX3400 then the FXP0?Regards,Neeraj.
View ArticleRRI, reverse route insertion, ARI
I have questions about ARI/RRI . First, does the SRX series utilize RRI as ARI ? It's my understanding that ARI is normal traffic flow.Another question, RRI contains an exception,so does this have...
View ArticleGoing crazy with subinterfaces on SRX300 cluster
Hi guys, I've been trying to set up subinterfaces on a SRX300 HA cluster and haven't been able to make it work. Straight to the point: I have reth2 and want to have there 2 subinterfaces, one on VLAN...
View ArticleSRX inter-zone vs. intra-zone
Hi Guys, I have been working with juniper SRXs for only a few months and thought i would run something past you guys with much more experience, With regards to security/functionality etc etc... there...
View ArticleSRX300 - Filter Based Forwarding
Hi all,I am trying (and failing) to configure Filter Based Forwarding on a SRX300 running 15.1X49-D140.2 . In a nutshell I am trying to forward traffic for a small number of hosts towards a RPi...
View ArticleIPV6, persistent-nat
SRX does not support persistent-nat for IPV6. At least not on version 11.4xxxx . I have read several posts about using the ipv4 persistency, for IPV6. natv6v4 seems one way. Can I use just that...
View ArticleRedistributing BGP into OSPF?
Can anyone help point me in the right direction. I've been searching for documentation or examples on redistrubting BGP routes over to OSPF. I have my cloud providers being delivered to us over two...
View ArticleNo IPV6 flow sessions....
I have enabled the ipv6 flow. All ipv6 traffic is running. I am not using IPV6 DHCP client because I haven't installed a newer version of junos. I am currently using 11.47xxx . I am not seeing any flow...
View Article(No) traffic through Dynamic VPN. Sometimes
Hello.I have a quite annoying problem. The most annoying thing about it is that it's somewhat erratic. For some users the VPN always works, but some report that the VPN gets properly connected but no...
View ArticleADSL config & ppp re-establishment
We have a problem with our ADSL interface not re-establishing when there is a drop. Allthough our line has been tested and proved to be working i am not convinced that this isn't the reason that our...
View Article