Seems like a trivial problem but if the led stays red it becomes useless.
This is a new install of an srx345. During install I created an internet disconnection alarm. This caused 2 alarm entrys - one chassis and one system with the date of the occurrence. (not a management disconnect issue). The internet is connected and functioning now.
I can't clear the leds. I don't care about the log.
I have rebooted, I have tried the CLI entry of clear led alarm . (This from an SSH via Mac terminal)
If I look for all possible uses of clear I don't find anything except clear errors which demands some further entry.
Unit is running fine otherwise. I have an ips installed.
Is this a software bug?
Is there some obscure incantation that I'm missing?
Thanks
Mark