Hi,
Following static NAT is not working, any suggestions?
root@213-ROUTER> show configuration | display set | match S1
set security nat static rule-set S1 from interface ge-0/0/5.0
set security nat static rule-set S1 rule r1 match destination-address 10.213.21.177/32
set security nat static rule-set S1 rule r1 then static-nat prefix 40.1.1.11/32
set security nat static rule-set S1 rule r1 then static-nat prefix routing-instance JCShubspoke
10.213.21.177 is the IP Address configured on interface ge-0/0/5 in routing-instance JCShubspoke.
40.1.1.11 is the IP Address of the internal server, connected via inteface ge-0/0/6 in routing-instance JCShubspoke.
The IP Address of ge-0/0/6 is 40.1.1.254.
My SRX is in packet mode , so no zones required. Proxy-arp is also not required, since I am directly using the same IP Address which is there on ge-0/0/5.
root@213-ROUTER> show security nat static rule all
Total static-nat rules: 1
Total referenced IPv4/IPv6 ip-prefixes: 2/0
Static NAT rule: r1 Rule-set: S1
Rule-Id : 1
Rule position : 1
From interface : ge-0/0/5.0
Destination addresses : 10.213.21.177
Host addresses : 40.1.1.11
Netmask : 32
Host routing-instance : JCShubspoke
Translation hits : 0
Successful sessions : 0
Failed sessions : 0
Number of sessions : 0