Hi all,
I have a feeling that this might not be supported, but I would like to confirm this in case I am missing something
Basically we would like to enable the ethernet-switching family on the VDSL2 interface on an SRX320 running JunOS v15.1. This VDSL2 line will be used as a backup, but it needs to share the same L2 domain as the builtin Ethernet ports.
After enabling switching mode, the ethernet-switching family can be enabled on the GigaEthernet ports, but this option does not seem to be available on the VDSL2 interface:
set interfaces ge-0/0/1 unit 0 family ethernet-switching interface-mode access
set interfaces ge-0/0/1 unit 0 family ethernet-switching vlan members vlan100
root@SRX320-VDSL# set interfaces pt-1/0/0 unit 0 family ?
Possible completions:
+ apply-groups Groups from which to inherit configuration data
+ apply-groups-except Don't inherit configuration data from these groups
> inet IPv4 parameters
> inet6 IPv6 protocol parameters
> iso OSI ISO protocol parameters
> mlfr-end-to-end Multilink Frame Relay end-to-end protocol parameters
> mlfr-uni-nni Multilink Frame Relay UNI NNI protocol parameters
> mlppp Multilink PPP protocol parameters
> mpls MPLS protocol parameters
The link below makes me thing that only builtin ports support that mode, but it does not talk about the SRX320:
https://kb.juniper.net/InfoCenter/index?page=content&id=KB15455&actp=METADATA
Anybody knows if this mode is/might be supported on those interfaces? If not, any ideas about how it could be implemented using different encapsulations? We are looking at converting the SRX320 into a VDSL2 bridge basically
Any ideas/comments will be more than welcome,
Kind regards,
C