Hello,
I am new to the Juniper line of products and I was wondering if you can create aggregated fabric link (2 interface on the primary chassis and 2 on the backup chassis). I did set up the fabric link configured using the commands below and it is up.
set interfaces fab0 fabric-options member-interfaces et-7/2/0
set interfaces fab1 fabric-options member-interfaces et-19/2/0
The fab link is up but I would like have a bigger pipe for the data connection between the clustered firewalls. So instead of having a 40gig pipe btwn chassis's, I would like to have a 80gig pipe. Is this possible with some type of LAG? I am running software version 12.1X46-D25.7 on each chassis. Thank you!
Regards,
TD