Dear Friends,
I am facing an issue with Cisco switch- Juniper SRX650 failover
I have 2 Nos 3750 stack switch- connected to SRX650(2 No's) Juniper devices with Failover
Let me explain the internal switch configuration
We have a stack switch setup (2 * Cisco 3750 hardware )
configuration as
interface Port-channel2
description To Firewall
no switchport
ip address 192.168.50.1 255.255.255.0
interface Port-channel4
description To Firewall
no switchport
ip address 192.168.51.1 255.255.255.0
Interface config###
interface GigabitEthernet1/0/23
description PortChannel to Juniper SRX2
no switchport
no ip address
channel-group 4 mode active
!
interface GigabitEthernet1/0/24
description PortChannel to Juniper SRX2
no switchport
no ip address
channel-group 4 mode active
interface GigabitEthernet2/0/23
description PortChannel to Juniper SRX1
no switchport
no ip address
channel-group 2 mode active
!
interface GigabitEthernet2/0/24
description PortChannel to Juniper SRX1
no switchport
no ip address
channel-group 2 mode active
# Routing #####
ip route 0.0.0.0 0.0.0.0 192.168.50.2
ip route 0.0.0.0 0.0.0.0 192.168.51.2 50
Current Physical Cabling ( While checking failover data traffic is not happening to switch in current setup)
GigabitEthernet2/0/23 & GigabitEthernet2/0/24 -> Juniper 1 (Port channel 2)
GigabitEthernet1/0/23 & GigabitEthernet1/0/24 -> Juniper 2 (Port channel 4)
Proposed physical change I am planning from switch side to Solve this issue (Please advice this will work or not.( Please advice what are the precautions we have to tak ebefore starting this activity, Ex:need to Shut down LACP in switch etc)
GigabitEthernet1/0/23 & GigabitEthernet2/0/24 -> Juniper 1 (Port channel 4 & Port channel 2)
GigabitEthernet2/0/23 & GigabitEthernet1/0/24 -> Juniper 2 (Port channel 2 & Port channel 4)
Now Channel Group 2 is active , while failover connection will switch to 4, But no traffic is initiating , I think Still the switch is forwarding traffic to channel group 2 interfaces.
Thanks in Advance
Sarath