We currently have other branch devices clustered over layer 2 network.
Now, with a newer cluster based on SRX340 and recommended JunOS, the cluster worked fine with direct cable, but once connected to layer 2 network it wont work.
We have EX-switches between them.
I can see the arp/mac-addresses for the control link.
I can see traffic statistics that the is incoming and outgoing on the interface. But the control link wont come logical up and it says it doesnt see the other cluster member.
Any ideas?
The layer 2 network is configed with jumbo-frames, and as access ports (same setup as other branch devices with older JunOS)
//Rob