Hi All.
I bought a new one Juniper SRX100B and decided to update the firmware to the last recomended version.
=> setenv serverip 172.16.1.1
=> setenv ipaddr 172.16.1.2
=> setenv netmask 255.255.255.0
=> save
Saving Environment to Flash...
Un-Protected 1 sectors
Erasing Flash...
. done
Erased 1 sectors
Writing to Flash... writing to flash...
done
Protected 1 sectors
=> ping 172.16.1.1
Using octeth0 device
host 172.16.1.1 is alive
=> tftpboot 0x100000 u-boot-crc.bin
Using octeth0 device
TFTP from server 172.16.1.1; our IP address is 172.16.1.2
Filename 'u-boot-crc.bin'.
Load address: 0x100000
Loading: #################################################################
############################################################
done
Bytes transferred = 639044 (9c044 hex)
=> bootloader upgrade u-boot active 0x100000
Checking sanity of backup u-boot...
WARNING: Image with missing CRC header.
Do you want to continue? [Y/N] (Default: N)Y
Un-Protected 10 sectors
...Flash erase timeout at address bfc30000 data 5c185c18
Flash erase timeout at address bfc40000 data 5c185c18
Flash erase timeout at address bfc50000 data 5c185c18
Flash erase timeout at address bfc60000 data 5c185c18
Flash erase timeout at address bfc70000 data 5c185c18
.Flash erase timeout at address bfc90000 data 5c185c18
done
Erased 10 sectors
Flash erase failed
WARNING: U-Boot upgrade failed
=> reset
After rebooting, there is ont a single symblol on the screen ((
What should I do next?