Hello all,
I am losing my mind here trying to figure out what I am doing wrong with this config. I am off-site from the device and am attempting to do some testing of different configurations and routing between devices. I have only made a few physical connections, and was hoping to be able to use VLAN interfaces as subinterfaces on one of the physical ports so that I could have multiple logically separate subnets.
I have tried using different unit numbers, and tried flexible vlan tagging but nothing seems to work. I have read probably 100 forum posts and articles that seem to have about 5 different ways of doing this and none of them seem to work, plus most aren't dealing with packet-mode and feel there is a bit of a disconnect in the support from one mode to another.
I have the physical all set up as a point to point link, but I would like to create another on the same physical port, tagged with VLAN 100 while leaving the below on Unit 0 as untagged.
I would like to place 172.20.20.1/30 on VLAN 100 on ge-0/0/2
ge-0/0/2 {
unit 0 {
family inet {
address 12.12.12.181/30;
Any ideas?